Mace HydroMace XCi, Product Manual, Page: 119 / 270

Ordering, renaming, setting of attributes and removing channels
Ordering configured channels
The channel list after “
Channels
” have been added reflects the order in which they were configured and in
which the XCi device takes physical measurements. This also orders the channels in both the logged data
and the LCD. For example, when scrolling through the displayed channels on the LCD, the output order will
be the same as the “
Configure channels
” dialogue box.
This order can be changed to suit the users needs
1. Highlight the “ Channel ” in the list you wish to move and click either the “ up ” or “ down ” arrows (where
available).
NOTE: The order is hierarchical and certain limitations apply. A “ Channel ”
that is dependent on the value of one or more channels cannot be moved
higher in the list than the lowest “ Channel ” upon which it depends.
Renaming configured channels
The channel names that have been given during the " Add channel " procedure can be changed at any time
afterwards.
1. Simply highlight the channel name that is to be changed, then right-click. Select " Rename channel "
and the " Channel name " dialogue box will appear, in which the channel name can be edited.
MACE XCi User Manual - 119 -