Mace HVFlo XCi, Product Manual

Page: 54 / 255

WARNING: Take care not to drop screws in the box as damage may occur to
the circuitry
3. Ground yourself again as per instructions in Step 1.
4. Remove the FloSeries3 card from its packaging. Position the new card in your hand such that the large
cream 48-pin connector is facing down and aligned with the mating connector on the backplane PCB.
5. Ground yourself again
. Your finger must remain grounded on the screw whilst carefully inserting
the card into any spare slot.Take care to align the pins of the two connectors together. There is a slot
at the top of the card area that helps the alignment process. Ensure that the card is contained within
this slot and press down firmly to ensure that it is fully seated.
NOTE: If installing a WebComm card then you MUST use card slot 5.
6. Replace the PCB clamping bracket ensuring that the slots in the underside of the bracket are aligned
with the tops of all the cards. Fix the bracket into place with the three screws.
MACE XCi User Manual - 54 -