MacDon R85, Installation Instructions Manual, Page: 29 / 42

INSTALLATION INSTRUCTIONS
3.7 Reinstalling Left-Hand Endshield and Frame Channel
To reinstall the left-hand endshield and frame channel, follow these steps. Unless damaged, reuse the original
hardware. Replacements are not included in the kit.
1. Position left-hand frame channel (A) over front
edge of top cover with left-hand corner shield (B)
hanging down.
NOTE:
Some parts were removed from the illustration
for clarity.
Figure 3.30: LH Front Corner of Header/Mower
Conditioner
2. Position left-hand endshield (A) with top edge over the
left-hand edge of the top cover. Fasten in place with
the following hardware retained from disassembly:
• One 1-1/4 in. long hex head bolt and a flange lock
nut at location (B)
• Two 3/4 in. long hex head flange bolts and distorted
thread flange nuts at location (C)
• Two 1 in. long hex head flange bolts at location (D)
Figure 3.31: LH Endshield
3. Reattach hook (A) to endshield with two 1-1/4 in. long
hex head bolts and flange lock nuts at location (B).
4. Reattach divider support (C) to endshield with two
1-1/4 in. long carriage bolts and flange lock nuts at
location (D) and one 1-1/2 in. long carriage bolt and
flange lock nut at location (E).
Figure 3.32: LH Endshield
147974
23
Revision B