MacDon R85, Installation Instructions Manual, Page: 23 / 42

INSTALLATION INSTRUCTIONS
3.5 Removing Left-Hand Endshield and Frame Channel
The new gearbox will not fit through the access panel in the top cover of the header/mower conditioner, so the
top cover must be lifted or removed. In order to do that, the left-hand endshield and frame channel must be
removed. To remove them, follow these steps:
NOTE:
This procedure assumes that the left-hand cutterbar door is still open from the previous procedure.
1. Remove the bolts (A) and nuts attaching the
hook (B) and the divider support (C) to the left-hand
endshield (D). Retain hook, divider support, and
hardware for reinstallation.
2. Remove the bolts (E) and nuts attaching the left-hand
endshield (D) to the header/mower conditioner, and
then remove the endshield. Retain the endshield and
hardware for reinstallation.
Figure 3.14: LH Endshield
3. Remove the left-hand frame channel (A) and corner
shield (B). Retain for reinstallation.
NOTE:
Some parts removed from illustration for clarity.
Figure 3.15: LH Front Corner of Header/Mower
Conditioner
147974
17
Revision B