215028
49
Revision A
Chapter 7:
Performing Predelivery Checks
Perform final checks and adjustments as listed on the yellow sheet attached at the back of this instruction to ensure the
machine is field-ready. Refer to the referenced pages as indicated on the Predelivery Checklist for detailed instructions.
The Operator or the Dealer should retain the completed Predelivery Checklist.
7.1
Conditioner Drive Belt
The conditioner drive belt is located inside the left driveshield and is tensioned with a spring tensioner.
7.1.1
Inspecting Conditioner Drive Belt
The conditioner drive belt tension is set at factory and should not require adjustment. To inspect the conditioner drive belt,
follow these steps:
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Lower the rotary disc header fully.
2.
Shut down the engine, and remove the key from the ignition.
1028480
A
Figure 7.1: Left Driveshield
3.
Open left driveshield (A).
1028323
A
B
C
Figure 7.2: Conditioner Drive
4.
Inspect drive belt (A) and replace if damaged or cracked.
5.
Check that jam nut (B) and adjuster nut (C) are tight.
