215028
41
Revision A
1014673
A
Figure 4.53: Calibration Page
8.
Press the PLAY button to begin the calibration process.
NOTE:
During the calibration sequence, the engine rpm and
header speed will increase and decrease multiple times.
NOTE:
Press the X button (A) on the screen or use the HEADER
DISENGAGE switch at any time during the calibration
process to exit calibration without saving. The engine speed
will return to the original rpm prior to starting the
calibration process.
4.1.8
Unpacking the Curtain
Follow these steps to unpack the cutterbar curtain on the rotary disc header:
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.
1.
Raise the header fully.
2.
Engage the header safety props. For instructions, refer to
8.2 Engaging and Disengaging Header Safety Props, page
69
.
1030486
A
A
A
A
A
A
C
C
C
C
C
C
C
C
B
Figure 4.54: Cutterbar Curtain
3.
Cut five straps (C) securing the cutterbar curtain to the
header.
4.
Loosen 12 nuts (A) under the rotary disc header top shield
2
–
3 turns to loosen bumper (B).
IMPORTANT:
Do
NOT
remove nuts (A) from the disc header; the
hardware should be loosened only enough so cable ties (C)
can be removed.
5.
Remove the five straps and discard.
