215028
17
Revision A
3.5
Installing Manual Rear Deflectors
There are four fins and two deflectors located under the baffle. The fins and deflectors require no adjustment from
shipping configuration to field position.
Install the rear deflectors as follows:
1028618
A
B
A
A
A
A
A
C
Figure 3.15: Deflector and Rear Baffle
–
View of baffle
edge Deflector Underside, Right Side of the Header
1.
Remove and retain hardware (A) securing deflector (B) to
rear baffle (C). Remove and retain deflector (B) from the
header. Repeat on the opposite side of the header.
NOTE:
There are three sets of hardware (A) on the baffle, but only
two sets hold deflector (B) in place in shipping position.
Ensure all three sets of hardware (A) are removed and
retained.
1028619
A
B
C
Figure 3.16: Baffle Handle and Baffle Bracket
2.
Remove pin (A) from baffle handle (B), and adjust the rear
baffle by placing handle (B) in center position on baffle
bracket (C).
1029740
A
B
C
Figure 3.17: Baffle Handle
3.
Replace pin (A) in baffle handle (B) to secure the handle in
fully raised position on baffle bracket (C).
