215028
7
Revision A
Chapter 2:
Unloading the Header from a Trailer
WARNING
To avoid injury to bystanders from being struck by machinery, do NOT allow people to stand in unloading area.
1013855
A
B
C
Figure 2.1: Minimum Lifting Capacity
A - Load Center of Gravity
B - Load Center 1220 mm (48 in.) from Back of Forks
C - Minimum Fork Length 1981 mm (78 in.)
IMPORTANT:
Equipment used for unloading the header must meet or
exceed the requirements specified below. Using inadequate
equipment may result in chain breakage, machine damage,
or the vehicle tipping.
NOTE:
Forklifts are normally rated for a load located 610 mm
(24 in.) ahead of the back end of the forks. To obtain the
forklift capacity at 1220 mm (48 in.), check with your
forklift distributor.
Table 2.1 Lifting Vehicle
Minimum Capacity
3630 kg (8000 lb.)
Minimum Fork Length
198 cm (78 in.)
1028160
Figure 2.2: Lifting Rotary Disc Header off Trailer
1.
Remove the hauler
’
s tie-down straps and chains.
WARNING
Be sure forks are secure before moving away from load. Stand
clear when lifting.
2.
Approach the rotary disc header from its underside and
slide the forks under the lifting framework as far as
possible.
IMPORTANT:
If the load is two units wide, take care to avoid contacting
the other machine.
3.
Raise the rotary disc header off the deck.
