215026
56
Revision A
3.8.2
Roll Tension
Roll tension (the pressure holding the conditioner rolls together) is factory-set to maximum and should rarely require
adjustment.
Heavy crops or tough forage can cause the rolls to separate; therefore, maximum roll tension is required to ensure that
materials are sufficiently crimped.
Adjusting Roll Tension
To adjust roll tension, follow these steps:
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Lower the header to the ground.
2.
Shut down the engine, and remove the key from the ignition.
1028475
A
B
Figure 3.77: Roll Tension Adjuster
3.
Loosen jam nut (A) on both sides of the conditioner.
4.
Adjust spring drawbolt as follows:
•
Turn spring drawbolt (B) clockwise to tighten spring and
INCREASE
the roll tension.
•
Turn spring drawbolt (B) counterclockwise to loosen
spring and
DECREASE
the roll tension.
IMPORTANT:
Turn each bolt equally. Roll tension changes by
approximately 32 N (7.2 lbf) with each turn of the drawbolt.
1028474
C
A
B
Figure 3.78: Roll Tension Adjuster
5.
Measure the amount of exposed thread on spring
drawbolt (A) at each end of the conditioner.
Measurement (B) should be 12
–
15 mm (1/2
–
9/16 in.).
6.
Tighten jam nut (C) on both sides of the conditioner.
