215026
168
Revision A
4.12
Electrical System
4.12.1
Maintaining Electrical System
•
Use electrical tape and cable ties as required to prevent the wiring harness from dragging or rubbing.
•
Keep lights clean.
•
Replace damaged lights.
4.12.2
Replacing Amber Hazard/Signal Light
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1027801
A
B
C
D
E
Figure 4.193: Left Amber Hazard/Signal Light
2.
Detach harness (A) on light (B) from main header
harness (C).
3.
Loosen nut (D), and then remove light (B) from light
bracket (E). Discard the light.
4.
Loosen nut (D) on new light fixture (B), then insert the light
into light bracket (E).
5.
Tighten nut (D) to secure the light in place. Torque to
16 Nm (12 lbf·ft).
6.
Connect light harness (A) to main header harness (C).
7.
Check operation of the new light.