MacDon R116, Unloading And Assembly Instructions

Page: 89 / 234

214713
81
Revision A
1014336
A
B
Figure 4.60: Cam Arm Alignment
4. Ensure the end of cam arm (A) is parallel with the clevis
end (B) of the cylinder. If adjustment is required, use a
bar and turn the clevis until the clevis is parallel with
cam arm (A).
NOTE:
The clevis end of cylinder will be attached to Road
Friendly Transport
™
system casting when the system is
primed. Refer to 5.5 Priming the Hitch Swing Cylinder,
page 102 .
4.8.3 Installing Hydraulic Lines and Hoses
This procedure explains how to install the transport hydraulic control system.
NOTE:
For hydraulic fitting installation details, refer to 11.6 Torque Specifications, page 208 .
1014890
A
B
C
Figure 4.61: Alignment Valve Fitting
1. Place a container or rag under the fitting on the hitch
swing cylinder.
2. Remove the existing fitting at location (A) from
the block.
3. Remove cap from fitting (C).
IMPORTANT:
Ensure O-ring is in place.
4. Retrieve ORFS-6 x ORB-6 connector (B) from shipping
bag A and install into location (A).
ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)