MacDon R116, Unloading And Assembly Instructions

Page: 87 / 234

214713
79
Revision A
4.8 Completing Road Friendly Transport
™ ™
System Installation
This section describes the installation of the base components, the hydraulic lines and hoses, and the electrical
connections for the Road Friendly Transport
™
system.
4.8.1 Removing Cover
1022610
A
B
Figure 4.56: Cover (Top View)
1. Remove bolts (B) from cover (A).
2. Remove cover (A).
4.8.2 Installing Transport Alignment Control
This section describes the installation of the base components of the Road Friendly Transport
™
system.
1014876
A
C
B
Figure 4.57: Alignment Control (Rear
Right View)
1. Secure the cam assembly (A) onto the hitch swing
cylinder plate (B) with bolts and nuts (C). Torque
nuts (C) to 55
–
60 Nm (40
–
45 lbf·ft).
NOTE:
When installing the cam assembly (A), check for hose
twisting. If required, loosen hose fitting to allow hose to
untwist. Torque fitting once complete.
ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)