3. Connect two mower conditioner
TILT
cylinder hoses
(C) to activate the following tractor hydraulic controls:
(Not required with mechanical center-link.)
Table 3.7 Mower Conditioner Tilt System
Control Lever
Position
Cylinder
Movement
Mower
Conditioner
Movement
Forward
Retract
Lower
Backward
Extend
Raise
3.8.4
Connecting Electrical Wiring Harness
1. Ensure that Pin #4 (A) in the tractor receptacle is
NOT
continuously energized (refer to your tractor operator’s
manual, and if required, remove the appropriate fuse.
IMPORTANT:
Older model tractors may have Pin #4 (A) energized
as an accessory circuit; however, pin position (B)
is used to supply power to the mower conditioner’s
brake lights.
2. Connect the mower conditioner wiring harness
connector (C) to the tractor receptacle.
NOTE:
The connector is designed to
fi
t tractors equipped
with a round seven-pin receptacle (SAE J560).
Figure 3.35: Electrical Wiring Harness
and Receptacle
169820
50
Revision A
