MacDon R113 SP, Operator'S Manual

Page: 46 / 240

215009
32
Revision A
3.4.2 Attaching R113 SP to M155 or M155 E4 SP Windrowers
–
Hydraulic Center-Link
with Optional Self-Alignment
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
1021748
A
B
C
Figure 3.24: Header Support
2. Remove hairpin (B) from clevis pin (A) and remove clevis
pin from header support (C) on both sides of the header.
1029714
A
B
Figure 3.25: Float Linkage
IMPORTANT:
To prevent damage to the lift system when lowering header
lift linkages without a header or weight box attached to the
windrower, ensure the float engagement pin is installed in
storage hole (B) and
NOT in engaged position (A).
3. Remove the float engagement pin from hole (A) to
disengage float springs, and insert float engagement pin
into storage hole (B). Secure with lynch pin. Repeat for
opposite linkage.
1008925
A
Figure 3.26: Ground Speed Lever
CAUTION
Check to be sure all bystanders have cleared the area.
4. Start the engine and activate HEADER DOWN button (A) on
the ground speed lever (GSL) to fully retract header lift
cylinders.
OPERATION