MacDon R113 SP, Operator'S Manual

Page: 39 / 240

215009
25
Revision A
1029799
A
Figure 3.6: Safety Prop
4. Disengage safety props on both lift cylinders as follows:
NOTE:
If safety prop will not disengage, raise header to release
the prop.
a. Turn lever (A) away from header to raise safety prop
until lever locks into vertical position.
b. Repeat for opposite cylinder.
CAUTION
Check to be sure all bystanders have cleared the area.
5. Start the engine, choose a level area, and lower header to
the ground. Shut down the engine and remove the key
from the ignition.
3.3.2 Engaging and Disengaging Header Safety Props
–
M Series Self-Propelled
Windrower
Safety props are located on both header lift cylinders on the windrower. Follow these steps to engage or disengage the
header safety props:
DANGER
To avoid bodily injury from fall of raised header, always engage safety props when working on or around raised header,
and before going under header for any reason.
Engage safety props as follows:
1008946
A
Figure 3.7: Ground Speed Lever (GSL)
1. Start engine and press HEADER UP switch (A) to raise
header to maximum height.
2. Rephase cylinders if one end of the header does not raise
fully. If rephasing is required, proceed as follows:
a. Press and hold the HEADER UP switch (A) until both
cylinders stop moving.
b. Continue to hold the switch for 3
–
4 seconds. Cylinders
are now phased.
OPERATION