MacDon R113 SP, Operator'S Manual

Page: 200 / 240

215009
186
Revision A
1021849
B
A
C
Figure 4.183: Tensioner
2. Position tensioner assembly (A) as shown, and secure with
M16 x 120 bolt (B) and nut (C). Torque nut (C) to 47
–
54 Nm
(35
–
40 lbf
∙
ft).
1021847
A
B
C
F
E
D
G
Figure 4.184: Tensioner
3. Install spring (A) into forward hole (B) in the frame.
4. Install eyebolt (C) onto spring (A) and tensioner (D). Secure
eyebolt (C) to tensioner (D) with hardened washer (E), and
two M10 nuts (F), and straight pin (G).
NOTE:
Install the conditioner drive belt after reattaching the
header to the adapter.
4.10.4 Replacing Shield
–
No Conditioner
Removing Discharge Shield (No Conditioner)
Follow these steps to remove the shielding installed on a disc header configured without a conditioner:
1021832
A
A
B
C
Figure 4.185: Left Side of Header
–
Right Opposite
1. Disconnect and remove the header from the windrower.
For instructions, refer to header operator
’
s manual.
2. On both ends of the header, remove four M16 hex head
bolts (A), nuts, and flat washers securing shield (B) to
header (C).
MAINTENANCE AND SERVICING