MacDon R113 SP, Operator'S Manual

Page: 191 / 240

215009
177
Revision A
4.10.3 Changing the Conditioner
The R113 SP Rotary Disc Header can be operated either with no conditioner, with a polyurethane roll conditioner, or with a
steel roll conditioner. If the disc header is not conditioner-equipped, a shield must be installed.
NOTE:
These instructions apply to all conditioners. Exceptions are identified where applicable.
Removing the Conditioner
This procedure is applicable when the header is not attached to the windrower. If necessary, detach the header from the
windrower before proceeding.
1. Remove the driveshields. For instructions, refer to Removing Driveshields, page 188 . For instructions, refer to header
operator
’
s manual or technical manual.
2. Remove the conditioner drive belt. For instructions, refer to Removing Conditioner Drive Belt, page 174 .
1021274
A
Figure 4.157: M1 Series Hose Bundle
3. M1 Series: Move hose bundle (A) clear of the frame and lay
it on the header.
1021272
B
A
Figure 4.158: M155 and M155 E4 SP Windrower Hoses
4. M155 and M155 E4 SP Windrower: Remove two bolts (A)
attaching hose bracket (B) to the header frame. Place the
hose bundle and bracket onto the header. Do
NOT
disconnect the hoses from the motor.
MAINTENANCE AND SERVICING