215333
45
Revision A
1030364
A
B
Figure 3.27: Drawbar Jack Storage
10. Move jack (A) to storage position on top of hitch, and
secure with pin (B).
11. Proceed to
3.7.3 Connecting Hydraulics, page 48
.
3.7.2
Attaching with Two-Point Hitch
Follow these steps to attach category II, IIIN, and III two-point hitches:
WARNING
To avoid bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key before making adjustments to the machine.
1003812
A
B
C
D
Figure 3.28: Two-Point Hitch Configuration
1.
Position the tractor and align hitch arms (A) with hitch
adapter (B).
2.
Shut down the engine, and remove the key from
the ignition.
3.
Remove lynch pins (C) and washers from the hitch adapter.
4.
Secure hitch arms (A) onto adapter pins (D) with lynch
pins (C).
NOTE:
If the tractor is equipped with a category III hitch, use a
bushing (MD #224322) on each hitch pin (D). Two bushings
(MD #224322) are included with the two-point hitch
assembly.
NOTE:
If using a category III hitch, a longer driveshaft may be
required. Refer to
5.1 Performance Kits, page 299
to order.
5.
Install anti-sway bars (not shown) on the tractor hitch to
stabilize lateral movement of hitch arms (A). For
instructions, refer to your tractor operator
’
s manual.
