215333
263
Revision A
Draining Rotary Disc Pull-Type Gearbox (T-Gearbox) Lubricant
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
IMPORTANT:
Drain the gearbox lubricant when the lubricant is warm. If the lubricant is cold, idle the machine for approximately
10 minutes prior to draining.
1.
Lower the rotary disc pull-type fully.
2.
Shut down the engine, and remove the key from the ignition.
1003631
Figure 4.290: Cutterbar Doors
3.
Open left cutterbar door. For instructions, refer to
.
1011078
A
B
Figure 4.291: Vertical Driveshield
4.
Remove four M10 hex flange head bolts (A) and vertical
driveshield (B).
