215333
210
Revision A
Installing Large Non-Driven Drums
–
R113 or R116 PT
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage lift cylinder lock-out valves before going under machine for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Shut down the engine, and remove the key from the
ignition.
1017492
A
Figure 4.172: Non-Driven Spindle
2.
Ensure spacer (A) is on spindle.
1024794
B
A
Figure 4.173: Non-Driven Drum
3.
Position non-driven drum/disc (B) onto spindle as shown.
4.
Use a 305 mm (12 in.) extension and 16 mm deep socket to
install four M12 bolts (A) and washers securing drum/disc
to spindle. Torque hardware to 85 Nm (63 lbf·ft).
