215333
167
Revision A
Changing R116 PT Cutterbar Crop Stream Configuration
1026420
A
B
10
9
8
7
6
5
4
3
2
1
Figure 4.74: R116 PT (10 Disc) Spindle Rotation Pattern and Crop Streams
A - One Crop Stream
B - Three Crop Streams
NOTE:
Refer to
Removing Cutterbar Spindles, page 158
and
Installing Cutterbar Spindles, page 160
To change R116 PT (10 disc) spindle rotation from one crop stream (A) to three crop streams (B):
•
Swap disc/spindle (7) with disc/spindle (4).
To change R116 PT (10 disc) spindle rotation from three crop streams (B) to one crop stream (A):
•
Swap disc/spindle (4) with disc/spindle (7).
4.4.7
Maintaining Disc blades
1004001
A
Figure 4.75: Disc blades
Each disc has two blades (A) attached at opposite ends that are
free to rotate horizontally on a specially designed shoulder bolt.
The blade (A) has two cutting edges and can be flipped over so
that the blade does not need replacing as often.
The blades are
NOT
repairable and must be replaced if severely
worn or damaged.
IMPORTANT:
Always use factory replacement parts.
NOTE:
Discs are equipped with 18° bevel-down blades; 11° bevel-down
blades are offered as a non-standard option. Refer to the R1 PT
Series Rotary Disc Pull-Type Parts Catalog.