MacDon PW8, Unloading And Assembly Instructions

Page: 23 / 170

214658
15
Revision A
3 Unloading the Header
Follow each of the procedures in this chapter in order.
3.1 Unloading with a Forklift
NOTE:
Extra hardware is stored inside the manual storage case at the back of the header. Loose parts are strapped to the
header.
NOTE:
MacDon recommends storing pick-up headers in the horizontal position after being received. If the units must be
stored in the vertical position, ensure the storage surface is flat and hard.
WARNING
Be sure all persons/pets are clear when moving the header.
CAUTION
To avoid injury to bystanders from being struck by machinery, do not allow anyone to stand in
unloading area.
CAUTION
Equipment used for unloading must meet or exceed the requirements specified below. Using inadequate
equipment may result in chain breakage, vehicle tipping, or machine damage.
Lifting Vehicle (Forklift or Equivalent)
Minimum Lifting Capacity
2
2270 kg (5000 lb.)
Minimum Fork Length
1981 mm (78 in.)
IMPORTANT:
Forklifts are normally rated for a load located 610 mm (24 in.) from back end of forks. To obtain forklift capacity at
1220 mm (48 in.), check with your forklift distributor.
2. At 1220 mm (48 in.) from back end of forks.