MacDon PW8, Unloading And Assembly Instructions

Page: 130 / 170

214658
122
Revision A
Setting Sensitivity of Auto Header Height Control to 200 (New Holland CR/CX Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1003627
Figure 6.98: New Holland Combine Display
1. Engage threshing and feeder house.
2. Select HEIGHT SENSITIVITY on combine
display screen.
3. Use + or
–
buttons to change setting to 200.
4. Press ENTER to save new setting.
NOTE:
The sensitivity can be changed from 10 to 250 in
increments of 10. It is factory-set to 100.
Setting Preset Cutting Height (New Holland CR/CX Series)
To set preset cutting height, follow these steps:
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
1014881
A
B
C
D
E
Figure 6.99: New Holland Combine Controls
1. Engage threshing mechanism and feeder with
switches (A) and (B).
2. Set HEADER MEMORY rocker switch (D) in STUBBLE
HEIGHT/AUTO FLOAT MODE.
3. Lower header to desired cutting height using HEADER
HEIGHT AND HEADER LATERAL FLOAT rocker
switch (C).
4. Press AUTOMATIC HEADER HEIGHT CONTROL
button (E) for a minimum of 2 seconds to store height
position. A beep will confirm setting.
NOTE:
It is possible to store two different header height values
by using HEADER MEMORY rocker switch (D) in
STUBBLE HEIGHT/AUTO FLOAT MODE.
PREDELIVERY INSPECTION