MacDon PW8, Unloading And Assembly Instructions

Page: 126 / 170

214658
118
Revision A
Calibrating Auto Header Height Control (New Holland CR/CX Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
Check the following conditions before starting the header calibration procedure:
•
The header is attached to the combine.
•
The combine is on level ground, with the header level to the ground.
•
The engine is running.
•
The combine is not moving.
•
No faults have been received from the Header Height Controller (HHC) module.
•
The header/feeder is disengaged.
•
Lateral float buttons are NOT pressed.
•
The ESC key is NOT pressed.
To calibrate the AHHC, follow these steps:
1. Select CALIBRATION on the combine display, and press the right arrow navigation key to enter the information
box.
1003605
A
Figure 6.92: New Holland Combine Display
2. Select HEADER (A), and press ENTER. The
CALIBRATION dialog box opens.
NOTE:
You can use the up and down navigation keys to move
between options.
PREDELIVERY INSPECTION