MacDon PW8, Operator'S Manual

Page: 167 / 304

214657
153
Revision A
4.1.10 New Holland Combines (CR Series
–
Model Year 2015 and Later)
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other
New Holland combine models, refer to
4.1.9 New Holland Combines CX/CR Series (CR Series
–
Model Year 2014
and Earlier), page 144 .
Engaging Auto Header Height Control (New Holland CR Series)
This procedure applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90).
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
1. Select TOOLBOX (A) on main page. The TOOLBOX page displays.
Figure 4.119: New Holland Combine Controls
2. Simultaneously press both UNLOAD (A) and
RESUME (B) buttons on hydro handle.
Figure 4.120: New Holland Combine Display
3. Select HEAD 1 (A). The HEADER SETUP 1 page
displays.
4. Select CUTTING TYPE drop-down arrow (B) and
change CUTTING TYPE to PLATFORM (C).
AHHC SYSTEM