MacDon PW8, Operator'S Manual

Page: 163 / 304

214657
149
Revision A
Figure 4.110: New Holland Combine Display
1. Select HEADER RAISE RATE on combine display.
2. Use + or
–
buttons to change setting.
3. Press ENTER to save new setting.
NOTE:
The raise rate can be changed from 32 to 236 in
increments of 34. The factory setting is 100.
Setting Header Lower Rate to 50 (New Holland CR/CX Series)
If necessary, header lower rate (using the automatic header height control button or second speed on header
height rocker switch of multifunction handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
Figure 4.111: New Holland Combine Display
1. Select HEADER LOWER RATE on combine display.
2. Use + or
–
buttons to change setting to 50.
3. Press ENTER to save new setting.
NOTE:
The lower rate can be changed from 2 to 247 in
increments of 7. It is factory-set to 100.
AHHC SYSTEM