MacDon PW8, Operator'S Manual

Page: 153 / 304

214657
139
Revision A
Figure 4.88: John Deere Combine Display
5. Press icon (A) with either FEEDER HOUSE SPEED or
HEADER selected and icon will turn green.
Figure 4.89: John Deere Combine Display
6. Click button (A) and instructions will appear on screen
to guide you through remaining calibration steps.
NOTE:
If an error code appears during calibration, one or both
sensors are out of voltage range and will require
adjustment. Refer to
Adjusting Header Height Sensor
Voltage Range (Left Side), page 105 and Adjusting
Header Height Sensor Voltage Range (Right Side),
page 105
.
Setting Sensitivity of Auto Header Height Control (John Deere S and T Series)
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
Figure 4.90: John Deere Combine
Command Center
1. Press button (A) twice and current sensitivity setting will
appear on combine display.
AHHC SYSTEM