MacDon PW8, Operator'S Manual

Page: 134 / 304

214657
120
Revision A
Figure 4.59: Case IH Combine Display
11. Follow calibration steps in the order they appear in
dialog box. As you proceed through calibration process,
display will automatically update to show next step.
NOTE:
The calibration procedure will stop if the system sits idle
for more than 3 minutes, or if the ESC key is pressed
during any step.
NOTE:
Refer to your combine operator
’
s manual for an
explanation of any error codes.
12. When all steps have been completed, CALIBRATION SUCCESSFUL is displayed on page. Exit CALIBRATION
menu by pressing ENTER or ESC key.
NOTE:
If float was set heavier to complete ground calibration procedure, adjust to recommended operating float after
calibration is complete.
13. If unit does not function properly, conduct maximum stubble height calibration.
Setting Preset Cutting Height (Case 7010/8010, 7120/8120/9120, 7230/8230/9230,
7240/8240/9240)
To set preset cutting height, follow these steps:
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
Figure 4.60: Case Combine Controls
A - Set #1 Switch B - Set #2 Switch
C - Header Height Mode Light D - Header Height Mode Light
E - Fine Adjust Switch
1. Engage separator and header.
2. Manually raise or lower header to desired cutting
height.
3. Press SET #1 switch (A). The HEADER HEIGHT
MODE light (C), next to SET #1 switch, turns on.
4. Manually raise or lower header to a second desired
cutting height.
5. Press SET #2 switch (B). The HEADER HEIGHT
MODE light (D), next to SET #2 switch, turns on.
AHHC SYSTEM