MAC215990
368
Revision A
4.11 Stripper Bars
Stripper bars are installed into the float module opening to improve feeding in crops such as rice. They may need to be
removed, depending on the desired float module configuration.
4.11.1
Removing Stripper Bars
The stripper bars are secured to the float module frame with four bolts and nuts.
1.
Detach the header from the combine. For instructions, refer to
3.6 Header Attachment/Detachment, page 55
1017291
B
A
Figure 4.234: Stripper Bars
2.
Remove four bolts and nuts (A) securing stripper bar (B) to
the float module frame, and remove the stripper bar.
3.
Repeat the previous step at the opposite side of the float
module.
4.11.2
Installing Stripper Bars
The stripper bars are installed in the lower corners of the float module opening.
1.
Detach the header from the combine. For instructions, refer to
