MAC215990
84
Revision A
3.8
Float Module Setup
The following sections outline the recommended float module setup guidelines for your specific combine model and crop
type; however, the recommendations cannot cover all conditions.
If feeding problems develop with the float module, refer to
.
3.8.1
FM200 Feed Auger Configurations
The FM200 feed auger can be configured to suit various crop conditions; there are five configurations available.
Ultra Narrow Configuration:
Ultra Narrow configuration uses 8 long bolt-on flightings (4 on the left and 4 on the right) and
18 auger fingers. This optional configuration may improve feeding performance on combines with narrow feeder houses. It
may also be helpful when harvesting rice.
1024961
A
B
Figure 3.54: Ultra Narrow Configuration
–
Rear View
A - 760 mm (29 15/16 in.)
B - 602 mm (23 11/16 in.)
NOTE:
Dimensions (A) and (B) are the same for both ends of the auger.
They should be within 15 mm (9/16 in.) of the numbers given.
NOTE:
You will need to drill holes in the flighting and in the drum to
install the extra flighting.
For more information on converting to Ultra Narrow
configuration, refer to
.
Narrow Configuration:
The narrow configuration uses 4 long bolt-on flightings (2 on the left and 2 on the right) and 18
feed auger fingers.
1021135
A
B
Figure 3.55: Narrow Configuration
–
Rear View
A - 514 mm (20 1/4 in.)
B - 356 mm (14 in.)
NOTE:
Dimensions (A) and (B) are the same for both ends of the auger.
They should be within 15 mm (9/16 in.) of the numbers given.
Narrow configuration
is a standard configuration for the
following combines:
•
New Holland CR 920/940/960, 9020/40/60/65, 6090/7090,
8060/8070/8080
