262171
252
Revision A
D
ϭϬϰϮϬϰϬ
A
B
C
Figure 5.122: HarvestTouch
™
Display
–
Draper
Header Shown
Settings for the fore-aft, reel height, and header height are
limited as follows to prevent the reel from colliding with the
cab roof:
•
If reel height (B) and header height (A) are both greater than
7.0, reel fore-aft (C) will be limited to 5.0. If you try to move
the reel fore-aft so the value would exceed 5.0, message (D)
("IMPORTANT: Reel position limited to prevent contacting
roof") will show on the HarvestTouch
™
Display.
•
If you want a reel fore-aft value of greater than 5.0, lower
the reel height and/or header height to a value of 7.0
or less.
•
The reel fore-aft will automatically move forward to 5.0 or
less If you increase the header height to greater than 7.0
while the reel fore-aft is greater than 5.0, and the reel
height is greater than 7.0.
After the reel fore-aft automatically moves, you will then have
to manually adjust the fore-aft.
5.5.4
Adjusting Reel Height
Optimize header performance based on crop type and conditions by adjusting the reel height position. The reel height
position is adjusted with the multi-function switches on the ground speed lever (GSL).
1019521
B
A
Figure 5.123: Ground Speed Lever
1.
Press and hold the switch for the desired movement of the
reel: UP (A) or DOWN (B).