MacDon M205, Operator'S Manual

Page: 213 / 514

214603
193
Revision A
4.3.9 Storing the Windrower
At the end of each operating season, you need to store your windrower properly.
WARNING
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials are toxic and
can be flammable.
CAUTION
Never operate engine in a closed building. Proper ventilation is required to avoid exhaust gas hazards.
CAUTION
Remember when working around storage batteries that all of the exposed metal parts are live. Never lay a
metal object across the terminals because a spark and short circuit will result.
1. Clean the windrower thoroughly.
2. Store windrower in a dry protected place.
3. Remove and store your batteries properly. Refer to Removing Batteries, page 354 .
4. Charge batteries, store in a cool, dry area in an upright position. Do NOT stack batteries on top of each other
unless they are in cartons.
5. If stored outside, cover windrower with a waterproof tarpaulin or other protective material. This will protect the
switches, instruments, tires, etc. from inclement weather.
6. If no cover is available, seal air cleaner intake and exhaust pipe with plastic bags and/or waterproof tape.
7. If possible, store the windrower on blocks to take weight off tires. If blocking up the machine is not possible,
increase tire pressure by 25% for storage. Adjust to recommended operating pressure before next use.
8. Repaint all worn or chipped painted surfaces to prevent rust.
9. Lubricate the windrower thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Apply
grease to exposed threads and sliding surfaces of components.
10. Check for worn components and repair. Tighten loose hardware and replace any missing hardware. Refer to
8.1 Recommended Torques, page 449 .
11. Check for broken components and order replacements from your Dealer. Attention to these items right away
will save time and effort at beginning of next season.
12. Add approved rust inhibitor to the engine oil in accordance with the manufacturer
’
s instructions. Run engine to
operating temperature to mix inhibitor with oil, unless otherwise specified.
13. To prevent condensation, fill hydraulic oil reservoir to filler neck with approved hydraulic system oil. Refer to
5.10.1 Checking and Filling Hydraulic Oil, page 385 .
14. Test engine coolant antifreeze concentration to ensure it is sufficient to protect engine against lowest
expected temperature.
OPERATION