MacDon M205, Operator'S Manual

Page: 170 / 514

214603
150
Revision A
1010024
ACTIVATE FUNCTIONS?
NO/YES
C###
X###
B
A
Figure 3.206: M205 Functions
5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
ACTIVATE HEADER HT is displayed on the
upper line.
1010038
DISC DRV SPD XXXX
D 0 P 0
- +
C###
X###
D
D
B
A
C
E
Figure 3.207: M205 Disc Drive
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (E) until DISC DRV SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT overspeed the disc drive.
8. Press and hold HAZARD (C) button.
•
Press left arrow (B) to decrease disc speed.
•
Press right arrow (D) to increase disc speed.
IMPORTANT:
Verify the disc drive is functioning properly.
9. Release the HAZARD (C) button. The disc drive
will stop.
10. Press PROGRAM (A) to exit programming mode or
press SELECT to proceed to next ACTIVATE
FUNCTION.
Testing the Double Windrower Attachment (DWA) Drive Activate Function Using the Cab
Display Module (CDM)
IMPORTANT:
Do not overspeed a drive. Overspeeding can lead to vibration, belt failures, or other overspeeding related
problems.
NOTE:
•
DWA must be attached to windrower and activated under the WINDROWER SETUP menu. For more
information, refer to
Activating the Double Windrow Attachment (DWA), page 98 .
•
Engine MUST be running to perform this procedure.
OPERATOR
’
S STATION