MacDon M205, Operator'S Manual

Page: 153 / 514

214603
133
Revision A
3.19.13 Troubleshooting Windrower Problems
Displaying the Windrower and Engine Error Codes
1022066
C###
X###
WINDROWER SETUP?
NO/YES
A
B
Figure 3.166: M205 CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter programming mode. Press
SELECT (B).
•
WINDROWER SETUP? is displayed on the
upper line.
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
•
NO/YES is displayed on the lower line.
1010019
DIAGNOSTIC MODE?
NO/YES
C###
X###
A
B
Figure 3.167: M205 Diagnostic Functions
4. Press right arrow (A) to select YES. Press SELECT (B).
5. VIEW ERROR CODES? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
VIEW WINDRWR CODES? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
1023541
VIEW WINDRWR CODES?
NO/YES
C###
X###
B
B
A
C
Figure 3.168: M205 Windrower Codes
7. Press right arrow (A) to select YES. Press SELECT (C).
•
The most recent error code will be displayed.
•
Refer to 8.5 Cab Display Module (CDM) Error
Codes, page 478 .
8. Press and left (A) or right (B) arrow to cycle through the
last ten recorded windrower error codes until EXIT
WINDROWER CODES is displayed.
9. Press right arrow (B) to select YES. Press SELECT (C).
•
VIEW ENGINE CODES is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
OPERATOR
’
S STATION