MacDon M205, Operator'S Manual

Page: 143 / 514

214603
123
Revision A
Adjusting the Cab Display Backlighting
The backlighting feature brightens the display screen helping you read the cab display module (CDM) in low light
situations.
1007188
C###
X###
WINDROWER SETUP?
NO/YES
A
B
Figure 3.142: M205 CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
1009975
C###
CAB DISPLAY SETUP?
NO/YES
X###
B
A
Figure 3.143: M205 Cab Display Setup
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
•
DISPLAY LANGUAGE? is displayed on the
upper line.
1009979
BACKLIGHTING
C###
X###
D
C
A
B
Figure 3.144: M205 Backlighting
5. Press SELECT (D) until BACKLIGHTING is displayed
on the upper line.
•
Default setting is displayed on the lower line.
6. Press left (B) or right (C) arrows to adjust display
backlighting.
7. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
OPERATOR
’
S STATION