214603
108
Revision A
Activating the Header Tilt Control Lockout
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
1009974
C###
X###
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.106: M205 CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1010005
NO/YES
SET CONTROL LOCKS?
C###
X###
B
A
Figure 3.107: M205 Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
Summary of Contents for M205
