MacDon M205 2010, Operator'S Manual

Page: 129 / 221

MAINTENANCE/SERVICE
Form 169469/169470/169471
127
Revision C
7.6 LUBRICATING THE WINDROWER
WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1, Preparation for
Servicing.
Recommend Lubricant
LUBRICANT SPEC DESCRIPTION USE
Grease
SAE Multi-
Purpose.
High Temp.
Extreme Pressure
(EP2)
Performance With
1% Max
Molybdenum
Disulphide (NLGI
Grade 2).Lithium
Base
As Required
Unless
Otherwise
Specified.
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Log hours of operation and use the
"Maintenance Checklist" provided to keep a
record of scheduled maintenance. Refer to
Section 7.13, MAINTENANCE SCHEDULE.
7.6.1 PROCEDURE
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
7.6.2 LUBRICATION POINTS
Refer to the illustrations on the following page
for identifying the various locations that require
lubrication.