215104
111
Revision A
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.29: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1011826
CXXX
EXXX
AUTO RAISE HEIGHT?
4.0
D
C
B
A
Figure 4.30: Auto Raise Height
4.
Press SELECT (D) until AUTO RAISE HEIGHT? is displayed on
the upper line.
•
Last measurement is displayed on the lower line.
NOTE:
The auto raise height ranges from 4.0 (minimum) to
9.5 (maximum), in 0.5 increments. A setting of 10 disables
the auto raise function.
5.
Press left arrow (B) or right arrow (C) to change auto raise
height.
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.3.8
Activating the Double Windrow Attachment
Follow this procedure if installing the Double Windrow Attachment (DWA); however, refer to the DWA manual if you
require additional installation instructions.
NOTE:
•
The DWA cannot be activated if the swath compressor is enabled.
•
Follow this procedure if installing a drive manifold (MD #139508).
CAUTION
Check to be sure all bystanders have cleared the area.
