215104
93
Revision A
1005753
A
Figure 3.131: Filler Cap
19. Check the hydraulic oil level in the reservoir (remove filler
cap / dipstick (A) and add SAE 15W-40 oil if necessary).
Refer to
3.19.5 Checking Hydraulic Oil Level, page 81
.
20. Close the platforms.
3.19.14
Checking and Adding Wheel Drive Lubricant
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
CAUTION
Park on a flat, level surface with the header on the ground, the ground speed lever (GSL) in N-DETENT position, and the
steering wheel in locked position (centered). Wait for the combine display module (CDM) to beep and display an
“
In
Park
”
message to confirm the park brakes have engaged.
1.
Park the windrower on level ground.
1007544
A
B
C
Figure 3.132: Drive Wheel Hub
2.
Position windrower so plugs (A) and (B) are horizontally
aligned with hub center (C).
3.
Shut down the engine, and remove the key from the
ignition.
4.
Remove plug (A) or (B). The lubricant should be visible
through the port or running out slightly.
5.
If lubricant needs to be added, remove the second plug (A)
or (B), and add lubricant until lubricant runs out from the
first port (A) or (B). For lubricant specifications, refer to
Lubricants, Fluids, and System Capacities, page 236
6.
Reinstall plugs and tighten.
3.19.15
Checking Traction Drive
CAUTION
Check to be sure all bystanders have cleared the area.
NOTE:
One person can perform this task.
