215015
150
Revision A
1009300
CXXX
MXXX
ACTIVATE REEL F/A
FORE/AFT
D
C
B
A
Figure 4.142: Reel Fore-Aft
7.
Press SELECT (D) until ACTIVATE REEL F/A is displayed on
the upper line.
•
FORE/AFT is displayed on the lower line.
8.
Verify reel fore-aft is functioning properly.
a.
Press and hold left arrow (B) to move reel forward.
Press and hold right arrow (C) to move reel backward.
b.
Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next ACTIVATE
FUNCTION.
4.9.9
Activating the Hydraulic Purge Using the Cab Display Module
The hydraulic purge removes air from the hydraulic pump system after it has been repaired or changed.
NOTE:
Engine
MUST
be running to perform this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.143: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
1009288
CXXX
MXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 4.144: Diagnostic Functions
3.
Press SELECT (B) until DIAGNOSTIC MODE? is displayed in
upper line.
•
NO/YES is displayed on the lower line.
4.
Press right arrow (A) to select YES. Press SELECT (B).
