215015
149
Revision A
4.9.8
Testing the Reel Fore-Aft Activate Function Using the Cab Display Module
NOTE:
•
The header
MUST
be attached to windrower to perform this procedure.
•
The engine
MUST
be running to perform this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.139: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
1009288
CXXX
MXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 4.140: Diagnostic Functions
3.
Press SELECT (B) until DIAGNOSTIC MODE? is displayed in
upper line.
•
NO/YES is displayed on the lower line.
4.
Press right arrow (A) to select YES. Press SELECT (B).
1009330
CXXX
MXXX
ACTIVATE FUNCTIONS?
NO/YES
B
A
Figure 4.141: Functions
5.
Press SELECT (B) until ACTIVATE FUNCTIONS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
6.
Press right arrow (A) to select YES. Press SELECT (B).
CAUTION
Check to be sure all bystanders have cleared the area.
