215015
141
Revision A
4.9.3
Testing the Header Tilt Activate Function Using the Cab Display Module
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
This procedure requires installation of the optional Hydraulic Center-Link (MD #B4650).
•
The engine
MUST
be running to perform this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.119: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
1009288
CXXX
MXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 4.120: Diagnostic Functions
3.
Press SELECT (B) until DIAGNOSTIC MODE? is displayed in
upper line.
•
NO/YES is displayed on the lower line.
4.
Press right arrow (A) to select YES. Press SELECT (B).
