215015
124
Revision A
4.6
Calibrating the Header Sensors
Sensor calibration programs the windrower control module (WCM) with settings for the attached header.
4.6.1
Calibrating the Header Height Sensor
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its configuration for each header type.
•
The engine
MUST
be running to perform this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.79: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
3.
Press SELECT (B) until CALIBRATE SENSORS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
1009281
CXXX
MXXX
CALIBRATING HEIGHT
RAISE HEADER HOLD
C
B
A
Figure 4.80: Header Height Calibration
4.
Press right arrow (B) to select YES. Press SELECT (C).
•
TO CALIBRATE SELECT is displayed in upper line.
5.
Press left (A) or right (B) arrow until HEADER HEIGHT is
displayed on the lower line. Press SELECT (C).
•
CALIBRATING HEIGHT is displayed on the upper line.
•
RAISE HEADER HOLD is displayed on the lower line.
