215015
101
Revision A
4.3.5
Setting the Header Index Mode
Index mode links reel and draper speed to ground speed. This feature is not applicable to rotary disc headers.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.25: M155 CDM Programming Buttons Shown
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009090
HEADER INDEX MODE?
CXXX
MXXX
REEL & CONVEYOR
D
C
B
A
Figure 4.26: M155 Header Index Mode Shown
4.
Press SELECT (D) until HEADER INDEX MODE? is displayed
on the upper line.
•
REEL & CONVEYOR or REEL ONLY is displayed on the
lower line.
5.
Press left (B) or right (C) arrows to set HEADER INDEX
mode. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.3.6
Setting the Return to Cut Mode
Return to Cut allows the Operator to resume preferred header positions and headland presets.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1.
Turn ignition key to RUN, or start the engine.
