215015
98
Revision A
4.3.2
Setting the Knife Overload Speed
The knife overload speed is the point at which a warning will appear on the cab display module (CDM). When the knife
speed drops below the knife overload speed setting, this indicates the knife drive is overloaded, and a warning is displayed.
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module automatically
adjusts its programming for each header.
•
The recommended knife overload speed is 75% of knife speed.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.19: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1009082
CXXX
MXXX
KNIFE OVERLOAD SPD?
-300 SPM
D
C
B
A
Figure 4.20: Knife Overload Speed
4.
Press SELECT (D) until KNIFE OVERLOAD SPD? is displayed
on the upper line.
•
Current overload speed is displayed on the lower line.
NOTE:
Default setting is -300 spm. Range is -500 to -100 spm.
5.
Press left (B) or right (C) arrows to set knife overload speed.
Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
