215676
71
Revision A
3.19.2
Header Functions
Several header functions such as the header float and the speed of the auger or draper (depending on the type of header
attached to the windrower) are controlled from the cab display module (CDM).
Figure 3.58: Cab Display Module (CDM)
1000645
A
B
C
D
E
F
G
•
DISPLAY (A)
–
Reports header performance information.
•
SELECT SWITCH (B)
–
Allows the Operator to select a display item on the lower line. Push the switch to select a
highlighted option.
•
FLOAT SWITCH (C)
–
Header right side: changes the header
’
s right float setting. If the deck shift option is installed on
the attached header, individual float settings can be configured for each deck shift delivery position. Push + to increase
the float ; push
–
to decrease it.
•
FLOAT SWITCH (D)
–
Header left side: changes the header
’
s left float setting. If the deck shift option is installed on the
attached header, individual float settings can be configured for each deck shift delivery position. Push + to increase the
float ; push
–
to decrease it.
NOTE:
Refer to
Setting Float Options with Deck Shift, page 299
for more information on configuring the deck shift float
presets.
•
AUGER/DRAPER SPEED ADJUST (E): changes the auger or draper speed index when index switch (F) is set to ON. When
index switch (F) is set to OFF, this switch is used to change the auger or draper speed. Push the upper switch to
increase this setting; push the lower switch to decrease it.
•
HEADER INDEX SWITCH (F): this switch is used to link the speed of the reel and the conveyor to the windrower
’
s ground
speed (
“
speed indexing
”
). Push the switch to turn speed indexing on; push it again to turn speed indexing off.
NOTE:
Header index switch (F) will light up when speed indexing is enabled.
