215676
322
Revision A
1000412
A
B
Figure 5.10: Platform Latch
2.
Unlock latch (A) and move platform (B) toward the open
position. Do
NOT
lock the platform in the fully aft position.
1000067
A
B
Figure 5.11: Platform
3.
Remove the nut and bolt securing link (A) to the frame.
Swing link (A) out of the way.
4.
Pull the front cab-forward end of the platform away from
the frame while moving it toward the walking beam. The
aft corner of platform (B) should project slightly into the
engine bay when the platform is in place.
5.4.4
Closing Platforms
–
Major Service Position
Once your servicing or maintenance tasks are complete, close the platform(s). This procedure applies to both platforms.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
1000067
A
B
Figure 5.12: Platform
1.
Swing link (A) all the way forward.
2.
Push front cab-forward end (B) of the platform towards the
frame while moving the platform forward.
3.
Position link (A) on the bracket and install the bolt and nut.
Tighten the hardware just enough, while still allowing the
link to swivel on the bracket.
