215676
296
Revision A
5.
Press DRAPER FAST (C) or SLOW (D) on the CDM until CDM (A) shows the message ##.## ##.# DRAP IND. Adjust the
value as needed.
•
The first term displayed on the CDM, ##.##, represents the draper speed in terms of rpm or mph or km/h,
depending on how the CDM is configured.)
•
The second term displayed on the CDM, #.##, represents the draper index value.
Examples:
•
The windrower is traveling at 13 km/h (8 mph) with the HEADER INDEX switch set to ON and the draper index value set
at 1.5.
The CDM will display: 9.5 1.5 DRAP INDX, where 9.5 (8 + 1.5) is the draper speed in mph and 1.5 is the header index
setting.
•
The windrower
’
s speed drops to 12 km/h (7.5 mph), while the header index value remains the same.
The CDM will display: 9.0 1.5 DRAP INDX, where 9.0 (7.5 + 1.5) is the draper speed in mph and 1.5 is the header index
setting.
•
The windrower is traveling at 13 km/h (8 mph) with the HEADER INDEX switch set to ON and the draper index value set
at 0.9.
The CDM will display: 8.9 0.9 DRAP INDX, where 8.9 (8 + 0.9) is the draper speed in mph and 0.9 is the header index
setting.
Adjusting Draper Speed without Indexing
The Operator can set their preferred draper speed without using the windrower
’
s indexing system by using the draper
speed controls on the cab display module (CDM).
1000793
A
B
C
D
E
Figure 4.298: Operator Console
NOTE:
This procedure can also be followed to change the draper speed while the windrower is in motion.
