215676
182
Revision A
18. Lift the center-link off of the header pin.
NOTE:
If the center-link self-alignment kit is installed, start the
engine and raise the center-link using the REEL UP switch
on the ground speed lever (GSL).
19. Slowly back the windrower away from the header.
1000769
A
B
C
D
Figure 4.45: Mechanical Link
20. If the windrower is equipped with a mechanical link,
disconnect the center-link:
a.
Loosen nut (A) and rotate barrel (B) to relieve the load
on the link.
b.
Remove cotter pin (D) on pin (C), and remove the pin.
Reinstall the pin in the header.
Converting from Transport Mode to Field Operation
Once the windrower and towed header have been moved to their new location, the windrower and header must be
converted back to field mode before they can be used for field work.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1000719
A
B
Figure 4.46: Electrical Harness
1.
Stop the engine, and remove the key from the ignition.
2.
Disconnect the electrical harness at connector (B) from the
windrower. Store harness (A) on the weight box.
