215676
117
Revision A
Activating Rotary Disc Speed Control Lockout
Activating the rotary disc speed control lockout in the windrower
’
s cab display module (CDM) prevents unauthorized
Operators from changing the disc speed of the attached rotary header.
NOTE:
•
This procedure applies to windrowers with attached rotary disc headers only.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
.
To activate the rotary disc speed control lockout:
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.134: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 3.135: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? appears on the
upper line.
•
NO/YES will appear on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
